Makcu Flashing

Manual on how to flash your Makcu so you can use it with no errors.

Pre-Setup

1. Run from Your 2nd PC: To avoid leaving temp files, make sure to run the AIO tool from your second PC (where files will be unpacked into a local temp folder).

2. Download the AIO Tool: Get the tool from here or Download.

3. Open the AIO Tool: Let it update automatically.

4. Requirement: You’ll need one USB cable to flash the PCB. This master cable will be connected to the second PC.

Flashing

1. Hold the LEFT button and plug the USB cable into the LEFT USB port.

1. After MAKCM is in flash mode, you should see "MCU connected in flash mode"

   
2. Click Flash Left on your AIO, wait for it to finish

1. Unplug the USB cable from the left port when your finished.

2. Plug the same the same cable into the RIGHT USB port, while holding the RIGHT button.

1. Click Flash Right on your AIO, wait for flash to finish.