DMA
  • DMA Card
    • Hardware Setup (Game PC)
    • FTDI Driver Setup (2nd PC)
    • Testing (2nd PC)
    • Troubleshooting
  • DMA Firmware
    • Firmware Flashing
  • Display Port Fuser
    • Fuser Overview
    • Fuser Setup
    • EDID Spoofing
  • KM Box
    • KM Box Net Setup
    • KM Box B+ Setup
Powered by GitBook
On this page
  1. KM Box

KM Box Net Setup

PreviousEDID SpoofingNextKM Box B+ Setup

Last updated 4 months ago

  1. Connect to your 2nd PC with the included USB cable. (Port #1)

  2. Connect to your main PC with the included USB cable. (Port #2)

  3. Connect your keyboard or mouse to either #3 or #4.

  1. In Control Panel, navigate to "Network and Internet"

  1. Press "Network and Sharing Center"

  1. Press "Changer adapter settings"

  1. Find the KM Box network that should have appeared, right click and select "Properties". If your KM Box is not showing please unplug and re-plug it in.

  1. Select "Internet Protocol Version 4 (TCP/IPV4)" and ensure that it is enabled.

  1. Select "Properties".

  1. "Use the following IP address"

  1. Enter the following IP Addresses: - IP Address: 192.168.2.100 - Subnet Mask: 255.255.255.0

  1. Close / save all of the dialog boxes and you are good to go!